How to Remove an Otterbox iPhone 4 Case

The first step to removing an Otterbox iPhone 4 case is to unplug the device. While the iPhone fits snugly inside the case, it can be difficult to remove it from the phone if it’s not removed from the phone. To do this, first remove the case from the device and open the port covers. Then, you can remove the silicone cover. Then, you can separate the case halves.

how to remove otterbox iphone 4

To remove the outer shell of your iPhone, simply lift the edge with a thin object. You can then peel away the rest of the case. The case will come off the phone. Once the outer shell is removed, you can pop open the plastic panel using a small flat-head screwdriver or a stiff credit card. Be careful not to pull down on the clips – you could damage the plastic.

After the case is opened, pry open the plastic clips and lift the phone out. The outer case should easily come off. The inner shell is usually held together by snaps or catches. To remove the inner shell, pry each catch apart with a stiff credit card or a flat head screwdriver. Remember to work from the front of the case, and don’t pull down on the clips as this could break them.

Once you’ve loosened the clips, remove the case from the device. The outer shell is held on by a seam that can be removed with a fingernail or a small, thin object. To remove the case, lift the rubber cap over the lightening port and remove it. Afterwards, pop off the outer shell and remove the plastic cover. If you’re unable to do this, you can always use a lanyard.

Once you’ve removed the case, you can try to remove the tension clips by pressing them with the edge of your finger. Then, push the sides of the case with a stiff credit card or a flat-head screwdriver and push them apart. Make sure that you lift the clips in the front of the case, and don’t pull them down. If you’re not careful, they might snap and cause damage to the phone.

To remove an Otterbox iPhone 4, the first step is to pop the clips. The clips are held in place by a series of clips and notches that are located on the edge of the case. Then, you can lift the inner shell by gently prying the clips open. Then, you can lift the plastic cover from the iPhone. This step may take a little bit of patience. But after you’ve removed the inner shell, you’re ready to install a new case.

To remove an Otterbox iPhone case, you must first open the case. There are tension clips on the front edge of the phone case. You need to pry these clips open by pressing them upward. To pry the clips, you should push them towards the front of the case. If you’re pulling on them too hard, they might break the plastic and result in the device’s disconnection. If you want to remove the case, follow the instructions provided by the manufacturer on the packaging.

After you have removed the case, you must remove the inner shell. There is a seam along the edge of the iPhone screen. To remove the case, you can lift the rubber cap from the lightening port. Next, you must pull the outer shell up. If you can’t do it without the help of a screwdriver, use a stiff credit card instead. But be careful not to pull the plastic. The tension clip can break the plastic.

Once the case is removed, the plastic will fall off. Then, you’ll need to remove the protective shell. You need to lift the case. Then, you’ll need to lift the case from the front. To do this, you need to pop the two clips on either side. This will allow you to easily remove the case. If you can’t do this, you will have to pry out the plastic with the help of a tool.